![panasonic wm-61a electret condenser mic capsule panasonic wm-61a electret condenser mic capsule](https://www.picclickimg.com/d/l400/pict/123664229444_/WM-61A-Electret-Condenser-Microphone-Capsule-from-UK-Seller.jpg)
- #Panasonic wm 61a electret condenser mic capsule how to
- #Panasonic wm 61a electret condenser mic capsule Pc
#Panasonic wm 61a electret condenser mic capsule how to
I don't know what to buy and how to build it.
#Panasonic wm 61a electret condenser mic capsule Pc
However, I don't understand how to make the circuit that would provide current to the mic and make it play nice with a mic input (on a PC or anywhere else). Ideally, I would eventually be able to make a couple of mics and use them both for measurement and recording. I assume I can find anything else I need at Radio Shack. I have found the described WM-61A electret capsule at. I stumbled across Siegfried Linkwitz's page on constructing a "high quality measurement and recording microphone with flat frequency response" here: Essentially, drc involves convolving a digital audio signal with an Inverse Impulse Response adjusted to your room, prior to analog (re)conversion and transmission to the loudspeakers. The mic's first job would be for use in 'Digital Room Correction' to better correct the response of our basic home stereo, which is all I have for a reference system while I compose. I have wanted one for years, but could never justify the cost. I'd like to try to build a diy measurement and recording microphone. In other words, as far as electronic projects go, I'm merely a slightly more fastidious and careful version of my eight-year-old nephew. If the parts are all included and there is a pre-printed board where I can insert and solder Part A where the pre-printed board says 'Part A'", and absolutely everything is spelled out in minute detail, then I can just barely handle it, by following the directions blindly.
![panasonic wm-61a electret condenser mic capsule panasonic wm-61a electret condenser mic capsule](https://vikash.info/audio/measurement_mic/images/wand01.jpg)
Most importantly, I have no idea of how to translate a circuit diagram into a practical project. In former days, I would fairly regularly solder mic plugs to cables, things like that, but would steer clear of anything electronic. Practical electronics knowledge: Even less. Beyond the most basic ideas, I'm pretty much lost. Even then, I have nearly zero understanding of how the circuit would function, or why. I don't remember what the symbols on a circuit diagram refer to without a cheatsheet. I am a trained musician and a composer who uses computers to make his compositions.Įlectronics knowledge: minimal. I will check in on this thread at least once a day and read and respond to questions and advice from anyone and everyone as best I can. I realize that people inexperienced in a particular domain tend to unknowingly include many irrelevant details and unknowingly leave out important ones. I am VERY inexperienced with electronics. I am new to this forum and am delighted to have discovered it! The FAQ stresses the need for lots of detail, particularly in posts from the inexperienced, so I have done my best. My first project: a diy measurement and recording microphone using the Panasonic WM-61A electret capsule?